Best buy pin housing connector9/26/2023 We've not been able to find anyone who makes a female JST RCY to female JR adapter cable (otherwise we would recommend that), so the best we can to is suggest two adapter cables to use in series. If you don't have a pin crimping tool or soldering equipment, your best option is probably to buy some cable adapters. See instructions 3 through 5 of Step 7 of the ELEV-8 v2 Assembly Guide for more detail. Use a heat gun, hair dryer, or soldering iron to shrink the tubing. Slide the heat-shrink tubing back over the connector so that there is not exposed metal wire or solder.If you don't have much soldering experience, we recommend practicing with some scrap wire first. Solder the wires together so that they exactly match the image below.If you have not done this before, follow Instructions 2 through 4 of Step 2 from the ELEV-8 v2 Assembly Guide. Slide a 1/2" long piece of heat shrink tubing down onto both 3-pin extension wires.Use the wire strippers to carefully remove about 1/4 inch (6 mm) of insulation from the end the red and black wires on the 3-pin extension cable and the gimbal cable assembly. Take each wire and twist it using your fingers to bring all of the individual wire strands together.Pull/cut off the white wire on the extension cable.Cut the 3-wire extension cable so that you have a 3" piece of wire with a connector on the end.Use your wire strippers or scissors to cut off the red "JST" connector, just behind the connector (see image for Option 1, Step 1).By removing the old connector on the gimbal cable assembly and soldering on a cable that already has a 3-pin female servo connector on the end, you can avoid having to crimp your own connector, but still end up with a reliable connection. Option 2 - Splice (Solder) Servo Extension Cableįor this method, you'll need a soldering iron, solder, a 3-wire servo extension cable (such as any of the cables in Parallax #751-00010), 1" of some 1/16" or 1/8" diameter heat-shrink tubing, and a heat gun if you have one. Slide the red wire into the center slot of the connector housing and the black wire into one of the sides, until they click into place.Before sliding the connectors into the housings, please check them against this inspection chart.You may find this YouTube tutorial helpful. ![]() Use your pin crimping tool to attach a female pin to the end of each wire.Use the wire strippers to carefully remove about 1/8 inch (3 mm) of insulation from the end of each wire. Take each wire and twist it using your fingers to bring all of the individual wire strands together. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |